Idea Into Product

The proposed motor is a magnetic power device, which uses energy of permanent magnets with interactions with each other. This device is technologically simple for manufacturing, if manufacturing (power of permanent magnets operate efficiently on a small distance) can be obtained from the device, which is the shaft power will give a large torque at the high revs.

Magnetic motor contains a shell, which has an opportunity to interact through the magnetic forces of permanent magnets with the opportunity of rotating parts, and with the fact that they are strictly parallel to each other and establish on the case of the four axes.

(more…)

Modern exhaust ventilation on the basis of centrifugal pump makes an equivalent noise of jet aircraft, so I suggest small speed exhaust ventilation for rooms where you need silence while the high concentration of workers or visitors (theaters, academic institutions, etc.).

The pump consists of: 1) body 2) restrictive ring 3) hinge 4) joint blade 5) rigid ring on the axle 6) axis in the center of rotation.

(more…)

Adjustable Water Pump for direct regulation of a wide array of management. It is suitable for use in hydraulic systems for various purposes including for the creation of infinitely hydraulic, which can be implemented continuously in the automotive transmission technology.

The basis of the invention laid gear Water Pump with efficiency over 90% and determining the ultimate characteristics of the controlled Water Pump. This pressure P-min and productivity V-max. Initial characteristics of the regulated pump – P-max and V-min.

Chart pressure, performance is not quite correct, but it is not fundamentally important. The main thing is that the initial pressure of the pump can be increased by several times. In two, three or more times. Theoretically, the pressure pump can be improved, and a hundred and a thousand times. This is not fundamentally. Depends only on the dimensions of the controlled pump. That is, the transfer rate does not depend on the actual pump, but is directly dependent on the dimensions of the controlled pump.

(more…)

Fig.1 schematically shows velomobile’s general view, in fig.2 – section A-A of fig.1, in fig.3 – section B-B of fig.1.
The proposed velomobile contains a frame 1, corpus 2, in which, with the possibility of rotation, there are cylinders 3 and 4; they are in the periodic toothed adhesion with item #5 of cylinder 3 with tooth 6, performed uniformly on the circle at cylinder 4. In addition, cylinders 3 and 4 have a parallel connection, and through the dentate outer normal mesh with the gear ratio equal to the number of teeth, 6 gears 7 and 8. Cylinders 3 and 4 are installed with the possibility of sliding of the cylindrical surfaces of each of other.

(more…)

We search for the investor for manufacturing the demonstration sample of installation on without waste ecologically pure manufacture of the electric power and reception of fresh water from atmospheric air for desert areas of the world (nearby 100 000 $ and 2-3 months on manufacturing of installation) and for the further joint realization of the project on the output on the international market for realization of installations of various capacity in the various countries with the hot droughty climate. (conditions of cooperation naturally stipulate) we hold a patent for separate basic unit of installation.

There is 3-d a computer model, drawings, calculations. The preliminary arrangement with factories where it is possible to order separate units and details for installation. The limit of capacity of installations it is practically unlimited. All depends on the borrowed area of installation.

(more…)